Enhance camcontrol(8) so that it's possible to manually set
frequency for SD/MMC cards.
While here, display more information about the current controller, such as
supported operating modes and VCCQ voltages, as well as current VCCQ voltage.
Details
Details
- Reviewers
imp manu - Commits
- rS363497: Make it possible to get/set MMC frequency from camcontrol
Run camcontrol on a detected card.
Example output for an eMMC card on Rock64:
root@r64:~ # camcontrol mmcsdcmd pass1 -I Host controller information Host OCR: 0x300000 Min frequency: 400 KHz Max frequency: 150 MHz Supported bus width: 4 bit 8 bit Supported operating modes: Can do High Speed transfers Can do eMMC HS200 at 1.8V Supported VCCQ voltages: 1.8V 3.3V Current settings: Bus width: 8 bit Freq: 150.000 MHz (high-speed timing) VCCQ: 1.8V
Diff Detail
Diff Detail
- Repository
- rS FreeBSD src repository - subversion
- Lint
Lint Not Applicable - Unit
Tests Not Applicable