Index: head/sys/mips/conf/DIR-825C1 =================================================================== --- head/sys/mips/conf/DIR-825C1 (revision 320463) +++ head/sys/mips/conf/DIR-825C1 (revision 320464) @@ -1,68 +1,61 @@ # $FreeBSD$ # # Specific board setup for the D-Link DIR-825C1 router. # # The DIR-825C1 has the following hardware: # # + AR9344 CPU SoC 74k MIPS # + ARxxx 2.4GHz 11n # + ARXXX 5GHz 11n # + AR8327 Gigabit switch # + m25p80 based 16MB flash # + 128MB RAM # + uboot environment #NO_UNIVERSE # Include the default AR934x parameters include "std.AR934X" ident DIR825C1 # Override hints with board values hints "DIR-825C1.hints" # Force the board memory - the base DB120 has 128MB RAM options AR71XX_REALMEM=(128*1024*1024) -# i2c GPIO bus -device gpioiic -device iicbb -device iicbus -device iic - # Options required for miiproxy and mdiobus options ARGE_MDIO # Export an MDIO bus separate from arge device miiproxy # MDIO bus <-> MII PHY rendezvous device etherswitch device arswitch # read MSDOS formatted disks - USB options MSDOSFS # Enable the uboot environment stuff rather then the # redboot stuff. options AR71XX_ENV_UBOOT # Used for the static uboot partition map device geom_map # uzip - to boot natively from flash options GEOM_UZIP options GEOM_PART_GPT # yes, this board has a PCI connected atheros device -device ath_pci options AR71XX_ATH_EEPROM device firmware # Used by the above options ATH_EEPROM_FIRMWARE # Boot off of the rootfs, as defined in the geom_map setup. options ROOTDEVNAME=\"ufs:map/rootfs.uzip\" # In order to netboot, you have to build the mfsroot into the kernel # 19443712 or 19M is the biggest rootfs via netboot this thing supports #options MD_ROOT # md device usable as a potential root device #options MD_ROOT_SIZE=19444 #makeoptions MFS_IMAGE=/tftpboot/mfsroot-dir825c1.img.ulzma #options ROOTDEVNAME=\"ufs:md0.uzip\"