diff --git a/sys/contrib/dev/rtw89/rtw8851be.c b/sys/contrib/dev/rtw89/rtw8851be.c
index 0f7711c50bd1..76216b790450 100644
--- a/sys/contrib/dev/rtw89/rtw8851be.c
+++ b/sys/contrib/dev/rtw89/rtw8851be.c
@@ -1,86 +1,89 @@
 // SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause
 /* Copyright(c) 2022-2023  Realtek Corporation
  */
 
 #include <linux/module.h>
 #include <linux/pci.h>
 
 #include "pci.h"
 #include "reg.h"
 #include "rtw8851b.h"
 
 static const struct rtw89_pci_info rtw8851b_pci_info = {
 	.txbd_trunc_mode	= MAC_AX_BD_TRUNC,
 	.rxbd_trunc_mode	= MAC_AX_BD_TRUNC,
 	.rxbd_mode		= MAC_AX_RXBD_PKT,
 	.tag_mode		= MAC_AX_TAG_MULTI,
 	.tx_burst		= MAC_AX_TX_BURST_2048B,
 	.rx_burst		= MAC_AX_RX_BURST_128B,
 	.wd_dma_idle_intvl	= MAC_AX_WD_DMA_INTVL_256NS,
 	.wd_dma_act_intvl	= MAC_AX_WD_DMA_INTVL_256NS,
 	.multi_tag_num		= MAC_AX_TAG_NUM_8,
 	.lbc_en			= MAC_AX_PCIE_ENABLE,
 	.lbc_tmr		= MAC_AX_LBC_TMR_2MS,
 	.autok_en		= MAC_AX_PCIE_DISABLE,
 	.io_rcy_en		= MAC_AX_PCIE_DISABLE,
 	.io_rcy_tmr		= MAC_AX_IO_RCY_ANA_TMR_6MS,
 
 	.init_cfg_reg		= R_AX_PCIE_INIT_CFG1,
 	.txhci_en_bit		= B_AX_TXHCI_EN,
 	.rxhci_en_bit		= B_AX_RXHCI_EN,
 	.rxbd_mode_bit		= B_AX_RXBD_MODE,
 	.exp_ctrl_reg		= R_AX_PCIE_EXP_CTRL,
 	.max_tag_num_mask	= B_AX_MAX_TAG_NUM,
 	.rxbd_rwptr_clr_reg	= R_AX_RXBD_RWPTR_CLR,
 	.txbd_rwptr_clr2_reg	= 0,
 	.dma_stop1		= {R_AX_PCIE_DMA_STOP1, B_AX_TX_STOP1_MASK_V1},
 	.dma_stop2		= {0},
 	.dma_busy1		= {R_AX_PCIE_DMA_BUSY1, DMA_BUSY1_CHECK_V1},
 	.dma_busy2_reg		= 0,
 	.dma_busy3_reg		= R_AX_PCIE_DMA_BUSY1,
 
 	.rpwm_addr		= R_AX_PCIE_HRPWM,
 	.cpwm_addr		= R_AX_CPWM,
 	.tx_dma_ch_mask		= BIT(RTW89_TXCH_ACH4) | BIT(RTW89_TXCH_ACH5) |
 				  BIT(RTW89_TXCH_ACH6) | BIT(RTW89_TXCH_ACH7) |
 				  BIT(RTW89_TXCH_CH10) | BIT(RTW89_TXCH_CH11),
 	.bd_idx_addr_low_power	= NULL,
 	.dma_addr_set		= &rtw89_pci_ch_dma_addr_set,
 	.bd_ram_table		= &rtw89_bd_ram_table_single,
 
 	.ltr_set		= rtw89_pci_ltr_set,
 	.fill_txaddr_info	= rtw89_pci_fill_txaddr_info,
 	.config_intr_mask	= rtw89_pci_config_intr_mask,
 	.enable_intr		= rtw89_pci_enable_intr,
 	.disable_intr		= rtw89_pci_disable_intr,
 	.recognize_intrs	= rtw89_pci_recognize_intrs,
 };
 
 static const struct rtw89_driver_info rtw89_8851be_info = {
 	.chip = &rtw8851b_chip_info,
 	.bus = {
 		.pci = &rtw8851b_pci_info,
 	},
 };
 
 static const struct pci_device_id rtw89_8851be_id_table[] = {
 	{
 		PCI_DEVICE(PCI_VENDOR_ID_REALTEK, 0xb851),
 		.driver_data = (kernel_ulong_t)&rtw89_8851be_info,
 	},
 	{},
 };
 MODULE_DEVICE_TABLE(pci, rtw89_8851be_id_table);
 
 static struct pci_driver rtw89_8851be_driver = {
 	.name		= "rtw89_8851be",
 	.id_table	= rtw89_8851be_id_table,
 	.probe		= rtw89_pci_probe,
 	.remove		= rtw89_pci_remove,
 	.driver.pm	= &rtw89_pm_ops,
+#if defined(__FreeBSD__)
+	.bsddriver.name	= KBUILD_MODNAME,
+#endif
 };
 module_pci_driver(rtw89_8851be_driver);
 
 MODULE_AUTHOR("Realtek Corporation");
 MODULE_DESCRIPTION("Realtek 802.11ax wireless 8851BE driver");
 MODULE_LICENSE("Dual BSD/GPL");
diff --git a/sys/contrib/dev/rtw89/rtw8852be.c b/sys/contrib/dev/rtw89/rtw8852be.c
index ecf39d2d9f81..be96ff56d699 100644
--- a/sys/contrib/dev/rtw89/rtw8852be.c
+++ b/sys/contrib/dev/rtw89/rtw8852be.c
@@ -1,90 +1,93 @@
 // SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause
 /* Copyright(c) 2020-2022  Realtek Corporation
  */
 
 #include <linux/module.h>
 #include <linux/pci.h>
 
 #include "pci.h"
 #include "reg.h"
 #include "rtw8852b.h"
 
 static const struct rtw89_pci_info rtw8852b_pci_info = {
 	.txbd_trunc_mode	= MAC_AX_BD_TRUNC,
 	.rxbd_trunc_mode	= MAC_AX_BD_TRUNC,
 	.rxbd_mode		= MAC_AX_RXBD_PKT,
 	.tag_mode		= MAC_AX_TAG_MULTI,
 	.tx_burst		= MAC_AX_TX_BURST_2048B,
 	.rx_burst		= MAC_AX_RX_BURST_128B,
 	.wd_dma_idle_intvl	= MAC_AX_WD_DMA_INTVL_256NS,
 	.wd_dma_act_intvl	= MAC_AX_WD_DMA_INTVL_256NS,
 	.multi_tag_num		= MAC_AX_TAG_NUM_8,
 	.lbc_en			= MAC_AX_PCIE_ENABLE,
 	.lbc_tmr		= MAC_AX_LBC_TMR_2MS,
 	.autok_en		= MAC_AX_PCIE_DISABLE,
 	.io_rcy_en		= MAC_AX_PCIE_DISABLE,
 	.io_rcy_tmr		= MAC_AX_IO_RCY_ANA_TMR_6MS,
 
 	.init_cfg_reg		= R_AX_PCIE_INIT_CFG1,
 	.txhci_en_bit		= B_AX_TXHCI_EN,
 	.rxhci_en_bit		= B_AX_RXHCI_EN,
 	.rxbd_mode_bit		= B_AX_RXBD_MODE,
 	.exp_ctrl_reg		= R_AX_PCIE_EXP_CTRL,
 	.max_tag_num_mask	= B_AX_MAX_TAG_NUM,
 	.rxbd_rwptr_clr_reg	= R_AX_RXBD_RWPTR_CLR,
 	.txbd_rwptr_clr2_reg	= 0,
 	.dma_stop1		= {R_AX_PCIE_DMA_STOP1, B_AX_TX_STOP1_MASK_V1},
 	.dma_stop2		= {0},
 	.dma_busy1		= {R_AX_PCIE_DMA_BUSY1, DMA_BUSY1_CHECK_V1},
 	.dma_busy2_reg		= 0,
 	.dma_busy3_reg		= R_AX_PCIE_DMA_BUSY1,
 
 	.rpwm_addr		= R_AX_PCIE_HRPWM,
 	.cpwm_addr		= R_AX_CPWM,
 	.tx_dma_ch_mask		= BIT(RTW89_TXCH_ACH4) | BIT(RTW89_TXCH_ACH5) |
 				  BIT(RTW89_TXCH_ACH6) | BIT(RTW89_TXCH_ACH7) |
 				  BIT(RTW89_TXCH_CH10) | BIT(RTW89_TXCH_CH11),
 	.bd_idx_addr_low_power	= NULL,
 	.dma_addr_set		= &rtw89_pci_ch_dma_addr_set,
 	.bd_ram_table		= &rtw89_bd_ram_table_single,
 
 	.ltr_set		= rtw89_pci_ltr_set,
 	.fill_txaddr_info	= rtw89_pci_fill_txaddr_info,
 	.config_intr_mask	= rtw89_pci_config_intr_mask,
 	.enable_intr		= rtw89_pci_enable_intr,
 	.disable_intr		= rtw89_pci_disable_intr,
 	.recognize_intrs	= rtw89_pci_recognize_intrs,
 };
 
 static const struct rtw89_driver_info rtw89_8852be_info = {
 	.chip = &rtw8852b_chip_info,
 	.bus = {
 		.pci = &rtw8852b_pci_info,
 	},
 };
 
 static const struct pci_device_id rtw89_8852be_id_table[] = {
 	{
 		PCI_DEVICE(PCI_VENDOR_ID_REALTEK, 0xb852),
 		.driver_data = (kernel_ulong_t)&rtw89_8852be_info,
 	},
 	{
 		PCI_DEVICE(PCI_VENDOR_ID_REALTEK, 0xb85b),
 		.driver_data = (kernel_ulong_t)&rtw89_8852be_info,
 	},
 	{},
 };
 MODULE_DEVICE_TABLE(pci, rtw89_8852be_id_table);
 
 static struct pci_driver rtw89_8852be_driver = {
 	.name		= "rtw89_8852be",
 	.id_table	= rtw89_8852be_id_table,
 	.probe		= rtw89_pci_probe,
 	.remove		= rtw89_pci_remove,
 	.driver.pm	= &rtw89_pm_ops,
+#if defined(__FreeBSD__)
+	.bsddriver.name	= KBUILD_MODNAME,
+#endif
 };
 module_pci_driver(rtw89_8852be_driver);
 
 MODULE_AUTHOR("Realtek Corporation");
 MODULE_DESCRIPTION("Realtek 802.11ax wireless 8852BE driver");
 MODULE_LICENSE("Dual BSD/GPL");