diff --git a/sys/arm/conf/IMX6 b/sys/arm/conf/IMX6 deleted file mode 100644 index dd8ca9266fad..000000000000 --- a/sys/arm/conf/IMX6 +++ /dev/null @@ -1,138 +0,0 @@ -# -# Kernel configuration for Freescale i.MX6 systems. -# -# For more information on this file, please read the config(5) manual page, -# and/or the handbook section on Kernel Configuration Files: -# -# https://docs.freebsd.org/en/books/handbook/kernelconfig/#kernelconfig-config -# -# The handbook is also available locally in /usr/share/doc/handbook -# if you've installed the doc distribution, otherwise always see the -# FreeBSD World Wide Web server (https://www.FreeBSD.org/) for the -# latest information. -# -# An exhaustive list of options and more detailed explanations of the -# device lines is also present in the ../../conf/NOTES and NOTES files. -# If you are in doubt as to the purpose or necessity of a line, check first -# in NOTES. -# -# $FreeBSD$ - -ident IMX6 -include "std.armv7" -include "../freescale/imx/std.imx6" - -options SOC_IMX6 - -options SCHED_ULE # ULE scheduler -#options NFSD # Network Filesystem Server -options INCLUDE_CONFIG_FILE # Include this file in kernel -options PLATFORM -options SMP # Enable multiple cores - -# NFS root from boopt/dhcp -#options BOOTP -#options BOOTP_NFSROOT -#options BOOTP_COMPAT -#options BOOTP_NFSV3 -#options BOOTP_WIRED_TO=ffec0 - -# U-Boot stuff lives on slice 1, FreeBSD on slice 2. -options ROOTDEVNAME=\"ufs:mmcsd0s2a\" - -# Interrupt controller -device gic -# Cache controller -device pl310 # PL310 L2 cache controller -# ARM MPCore timer -device mpcore_timer - -# Pseudo devices. -device loop # Network loopback -device vlan # 802.1Q VLAN support -device tuntap # Packet tunnel. -device md # Memory "disks" -#device gif # IPv6 and IPv4 tunneling -#device firmware # firmware assist module -device ether # Ethernet support -device miibus # Required for ethernet -device bpf # Berkeley packet filter (required for DHCP) - -# General-purpose input/output -device gpio - -# Serial (COM) ports -device uart # Multi-uart driver - -# SDCard -device sdhci # SD controller -device mmc # SD/MMC protocol -device mmcsd # SDCard disk device - -# SCSI peripherals -device scbus # SCSI bus (required for ATA/SCSI) -device da # Direct Access (disks) -device cd # CD -device pass # Passthrough device (direct ATA/SCSI access) - -# ATA controllers -device ahci # AHCI-compatible SATA controllers - -# USB support -device ehci # OHCI USB interface -device usb # USB Bus (required) -device umass # Disks/Mass storage - Requires scbus and da -device uhid # "Human Interface Devices" -device u3g # USB modems -#device ukbd # Allow keyboard like HIDs to control console -#device ums # USB mouse - -# USB Ethernet, requires miibus -#device aue # ADMtek USB Ethernet -#device axe # ASIX Electronics USB Ethernet -#device cdce # Generic USB over Ethernet -#device cue # CATC USB Ethernet -#device kue # Kawasaki LSI USB Ethernet -#device rue # RealTek RTL8150 USB Ethernet -#device udav # Davicom DM9601E USB - -# USB Wireless -#device rum # Ralink Technology RT2501USB wireless NICs - -# Wireless NIC cards -#device wlan # 802.11 support -#device wlan_wep # 802.11 WEP support -#device wlan_ccmp # 802.11 CCMP support -#device wlan_tkip # 802.11 TKIP support -#device wlan_amrr # AMRR transmit rate control algorithm - -# HID support -device hid # Generic HID support - -device vt -device kbdmux -device ukbd -device videomode -device hdmi - -# Flattened Device Tree -options FDT # Configure using FDT/DTB data -makeoptions MODULES_EXTRA="dtb/imx6 imx" -device fdt_pinctrl # FDT pinmux driver - -# pseudo devices -device clk -device phy -device hwreset -device nvmem -device regulator -device syscon - -# SoC-specific devices -device ffec # Freescale Fast Ethernet Controller -device fsliic # Freescale i2c/iic -device iic # iic protocol -device iicbus # iic bus -device imx6_snvs # On-chip RTC -device imxwdt # Watchdog. WARNING: can't be disabled!!! -