- Queries
- All Stories
- Search
- Advanced Search
- Transactions
- Transaction Logs
Feed Advanced Search
Advanced Search
Advanced Search
Jan 16 2019
Jan 16 2019
Suppress excessive error prints in ENA TX hotpath
Create 1.1.4.6 tag in ena-com
Suppress excessive print in ENA HAL
Dec 20 2018
Dec 20 2018
Fix obtaining RSP address in TPM CRB for non-amd64 platforms
Dec 19 2018
Dec 19 2018
Fix alignment issue in uefisign
Include the new TPM 2.0 driver in the TPM module.
Dec 14 2018
Dec 14 2018
Fix error check for ACPI_ID_PROBE in the TPM2.0 driver
Fix TPM driver compilation from r342084
Introduce driver for TPM 2.0 in CRB and FIFO (TIS) modes
Oct 10 2018
Oct 10 2018
Update Armada 38x UART device tree binding
Sep 15 2018
Sep 15 2018
MFC r333454: Skip setting the MTU for ENA if it is not changing
Aug 28 2018
Aug 28 2018
Use ip/ipv6 structures in al_eth only if they are supported
Jul 13 2018
Jul 13 2018
Enable UART support for Xilinx Ultrascale+ SoCs
May 10 2018
May 10 2018
Do not pass header length to the ENA controller
Skip setting the MTU for ENA if it is not changing
Create 1.1.4.4 tag in ena-com
Upgrade ENA version to v0.8.1
May 3 2018
May 3 2018
Add Marvell ArmadaXP and Armada38X to GENERIC config
Fix SoC identification issue on Marvell platforms
Apr 27 2018
Apr 27 2018
Revert r333035 due broken booting on !Marvell GENERIC platforms
Apr 26 2018
Apr 26 2018
Add Marvell ArmadaXP and Armada38X to GENERIC config
Add support for gpioled on ARMADA38X based boards
mw committed rS333032: Replace FDT tree parsing with gpio_map_gpios implementation in mv_gpio driver.
Replace FDT tree parsing with gpio_map_gpios implementation in mv_gpio driver
Update mv_gpio driver to new FreeBSD API
Apr 24 2018
Apr 24 2018
In D15141#319869, @andrew wrote:In D15141#319851, @pdk_semihalf.com wrote:It is good idea to provide support using quirks, however pci_host_generic_acpi still needs some resource allocation changes. I have limited ability to check if it doesn't break another devices, so from my point of view it is safe to provide separate driver.
There are no other devices, it only works on ThunderX2.
Apr 10 2018
Apr 10 2018
Remove deprecated DT sources of Armada 38x SoCs
Improve detection of addressing mode in e6000sw
Apr 9 2018
Apr 9 2018
Enable cesa driver to work with Linux DT binding
Apr 4 2018
Apr 4 2018
Hi @manu , do you have any objections to the patch?
Enable Marvell gpio driver to work with many controllers
Improve interrupt and resource allocation in Marvell GPIO driver
Introduce port debouncing mechanism in mv_gpio driver
Match Marvell Armada38X PCIE ranges in dts with Linux
Change reg in Marvell Armada38X pcie FDT
Add api for creating resource list based on 'assigned-addresses'
Match Marvell Armada38X PCI compatible with Linux
Add support of PCI_RES_BUS to Marvell PCI driver
Make Marvell armv7 timer and wdt registers definitions common
Make Marvell Armada reset registers usage generic
Use PLATFORM for initializing Marvell ArmadaXP and Armada38X
Apr 3 2018
Apr 3 2018
Fix kernel modules names for Marvell armv7
Split out delay code in Marvell timer driver for PLATFORM
Add missing flag check in Marvell PCIE driver
Make Marvell AmadaXP timer driver more generic
Make Marvell Armada watchdog driver more generic
Make get_tclk and get_cpu_freq generic for Marvell armv7 SoCs
Make mv_common.c generic for Marvell Armada38X and ArmadaXP
Make validation in Marvell mv_common.c generic
Split get_sar_value function for Marvell ArmadaXP and Armada38X
Make Marvell mv_pci.c driver generic
Enable ArmadaXP using INTRNG interrupt controller
Mar 21 2018
Mar 21 2018
@andrew Right, I looked more closely at the icon after posting my comment :)
@manu I se you NACKed the patch, but don't see the actual remarks
HI Manu,
Hi Manu,
Mar 8 2018
Mar 8 2018
Display NVMe data properly on Big Endian hosts with sysutils/smartmontools
Nov 9 2017
Nov 9 2017
Fix setting AENQ group in ENA driver
Allow usage of more RX descriptors than 1 in ENA driver
Read max MTU from the ENA device