Changeset View
Changeset View
Standalone View
Standalone View
sys/arm64/conf/std.marvell
- This file was added.
| # | |||||
| # Marvell SoC support | |||||
| # | |||||
| # SoC support | |||||
| options SOC_MARVELL_8K | |||||
| # CPU frequency control | |||||
| device cpufreq | |||||
| # Bus drivers | |||||
| device pci | |||||
| options PCI_HP # PCI-Express native HotPlug | |||||
| options PCI_IOV # PCI SR-IOV support | |||||
| # Block devices | |||||
| device ahci | |||||
| device scbus | |||||
| device da | |||||
| # ATA/SCSI peripherals | |||||
| device cd # CD | |||||
| device pass # Passthrough device (direct ATA/SCSI access) | |||||
| # NVM Express (NVMe) support | |||||
| device nvme # base NVMe driver | |||||
| options NVME_USE_NVD=0 # prefer the cam(4) based nda(4) driver | |||||
| device nvd # expose NVMe namespaces as disks, depends on nvme | |||||
| # GPIO / PINCTRL | |||||
| device a37x0_gpio # Marvell Armada 37x0 GPIO controller | |||||
| device gpio | |||||
| device gpioled | |||||
| device fdt_pinctrl | |||||
| device gpioregulator | |||||
| device mv_gpio # Marvell GPIO controller | |||||
| device mvebu_pinctrl # Marvell Pinmux Controller | |||||
| # I2C | |||||
| device a37x0_iic # Armada 37x0 I2C controller | |||||
| device iicbus | |||||
| device iicmux | |||||
| device iic | |||||
| device icee # Generic IIC eeprom | |||||
| device twsi # Allwinner/Marvell I2C controller | |||||
| # Interrupt controllers | |||||
| device mv_cp110_icu # Marvell CP110 ICU | |||||
| device mv_ap806_gicp # Marvell AP806 GICP | |||||
| device mv_ap806_sei # Marvell AP806 SEI | |||||
| # Real-time clock support | |||||
| device mv_rtc # Marvell Real-time Clock | |||||
| # Crypto accelerators | |||||
| device armv8crypto # ARMv8 OpenCrypto module | |||||
| device safexcel # Inside Secure EIP-97 | |||||
| # Thermal sensors | |||||
| device mv_thermal # Marvell Thermal Sensor Controller | |||||
| # SPI | |||||
| device spibus | |||||
| device a37x0_spi # Marvell Armada 37x0 SPI Controller | |||||
| # Console | |||||
| device vt | |||||
| device kbdmux | |||||
| device vt_efifb | |||||
| # EVDEV support | |||||
| device evdev # input event device support | |||||
| options EVDEV_SUPPORT # evdev support in legacy drivers | |||||
| device uinput # install /dev/uinput cdev | |||||
| # Serial (COM) ports | |||||
| device uart # Generic UART driver | |||||
| device uart_mvebu # Armada 3700 UART driver | |||||
| device uart_ns8250 # ns8250-type UART driver | |||||
| device uart_snps | |||||
| # PCI/PCI-X/PCIe Ethernet NICs that use iflib infrastructure | |||||
| device iflib | |||||
| device em # Intel PRO/1000 Gigabit Ethernet Family | |||||
| device ix # Intel 10Gb Ethernet Family | |||||
| # Ethernet NICs | |||||
| device mdio | |||||
| device mii | |||||
| device miibus # MII bus support | |||||
| device msk # Marvell/SysKonnect Yukon II Gigabit Ethernet | |||||
| device neta # Marvell Armada 370/38x/XP/3700 NIC | |||||
| device re # RealTek 8139C+/8169/8169S/8110S | |||||
| device smc # SMSC LAN91C111 | |||||
| # Etherswitch devices | |||||
| device etherswitch # Enable etherswitch support | |||||
| device miiproxy # Required for etherswitch | |||||
| device e6000sw # Marvell mv88e6085 based switches | |||||
| # Pseudo devices. | |||||
| device crypto # core crypto support | |||||
| device loop # Network loopback | |||||
| device ether # Ethernet support | |||||
| device vlan # 802.1Q VLAN support | |||||
| device tuntap # Packet tunnel. | |||||
| device md # Memory "disks" | |||||
| device gif # IPv6 and IPv4 tunneling | |||||
| device firmware # firmware assist module | |||||
| # EXT_RESOURCES pseudo devices | |||||
| options EXT_RESOURCES | |||||
| device clk | |||||
| device phy | |||||
| device hwreset | |||||
| device nvmem | |||||
| device regulator | |||||
| device syscon | |||||
| # The `bpf' device enables the Berkeley Packet Filter. | |||||
| # Be aware of the administrative consequences of enabling this! | |||||
| # Note that 'bpf' is required for DHCP. | |||||
| device bpf # Berkeley packet filter | |||||
| # USB support | |||||
| options USB_DEBUG # enable debug msgs | |||||
| options USB_HOST_ALIGN=64 # Align usb buffers to cache line size. | |||||
| device ohci # OHCI USB interface | |||||
| device uhci # UHCI USB interface | |||||
| device ehci # EHCI USB interface (USB 2.0) | |||||
| device ehci_mv # Marvell EHCI USB interface | |||||
| device xhci # XHCI USB interface (USB 3.0) | |||||
| device usb # USB Bus (required) | |||||
| device ukbd # Keyboard | |||||
| device umass # Disks/Mass storage - Requires scbus and da | |||||
| # USB ethernet support | |||||
| device muge | |||||
| device smcphy | |||||
| device smsc | |||||
| device ure | |||||
| # Sound support | |||||
| device sound | |||||
| # MMC/SD/SDIO Card slot support | |||||
| device sdhci | |||||
| device sdhci_xenon # Marvell Xenon SD/MMC controller | |||||
| device mmc # mmc/sd bus | |||||
| device mmcsd # mmc/sd flash cards | |||||
| options FDT | |||||
| device acpi | |||||
| # DTBs | |||||
| makeoptions MODULES_EXTRA+="dtb/mv" | |||||
| # HID support | |||||
| options HID_DEBUG # enable debug msgs | |||||
| device hid # Generic HID support | |||||