Differential D14547 Diff 39961 tests/sys/netinet/route_test.sh

Changeset View

Standalone View

tests/sys/netinet/route_test.sh

This file was added.

				#
				# Copyright (c) 2014 Dell Inc
				# All rights reserved.
				#
				# Redistribution and use in source and binary forms, with or without
				# modification, are permitted provided that the following conditions
				# are met:
				# 1. Redistributions of source code must retain the above copyright
				# notice, this list of conditions, and the following disclaimer,
				# without modification.
				# 2. Redistributions in binary form must reproduce at minimum a disclaimer
				# substantially similar to the "NO WARRANTY" disclaimer below
				# ("Disclaimer") and any redistribution must be conditioned upon
				# including a substantially similar Disclaimer requirement for further
				# binary redistribution.
				#
				# NO WARRANTY
				# THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
				# "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
				# LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTIBILITY AND FITNESS FOR
				# A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
				# HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
				# DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
				# OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
				# HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT,
				# STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING
				# IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
				# POSSIBILITY OF SUCH DAMAGES.

				# All of the tests in this file requires the test-suite config variable "fibs"
				# to be defined to a space-delimited list of FIBs that may be used for testing.

				. $(atf_get_srcdir)/route.subr

				# Test that a route can be modified with "route change $SUBNET/$MASK" without
				# needing to also specify the gateway of the route.
				atf_test_case ipv4_change_route_without_dest cleanup
				ipv4_change_route_without_dest_head()
				{
				atf_set "descr" "Test modifying a route without re-specifying its gateway"
				atf_set "require.user" "root"
				atf_set "require.config" "fibs"
				}

				ipv4_change_route_without_dest_body()
				{
				# Configure the TAP interfaces to use a RFC5737 nonrouteable addresses
				# and a non-default fib
				SUBNET_PREFIX="192.0.2"
				SUBNET="${SUBNET_PREFIX}.0"
				ADDR0="${SUBNET_PREFIX}.1"
				ADDR1="${SUBNET_PREFIX}.2"

				MASK="24"

				# Check system configuration
				if [ 0 != `sysctl -n net.add_addr_allfibs` ]; then
				atf_skip "This test requires net.add_addr_allfibs=0"
				fi
				get_fibs 1

				setup_tap "$FIB0" inet ${ADDR0} $MASK
				ifconfig $TAP mtu 9000

				atf_check -s exit:0 -o ignore setfib $FIB0 route change \
				${SUBNET}/${MASK} -mtu 8723

				# Just searching for "8723" is awful, but the output of 'route get' is
				# not amenable to parsing
				atf_check -o match:8723 setfib $FIB0 route get $ADDR1
				}

				ipv4_change_route_without_dest_cleanup()
				{
				cleanup_ifaces
				}

				# Test that a route can be modified with "route change $SUBNET/$MASK" without
				# needing to also specify the gateway of the route.
				atf_test_case ipv6_change_route_without_dest cleanup
				ipv6_change_route_without_dest_head()
				{
				atf_set "descr" "Test modifying a route without re-specifying its gateway"
				atf_set "require.user" "root"
				atf_set "require.config" "fibs"
				}

				ipv6_change_route_without_dest_body()
				{
				# Configure the TAP interfaces to use a RFC5737 nonrouteable addresses
				# and a non-default fib
				SUBNET_PREFIX="2001:db8:"
				SUBNET="${SUBNET_PREFIX}:0"
				ADDR0="${SUBNET_PREFIX}:1"
				ADDR1="${SUBNET_PREFIX}:2"

				MASK="64"

				# Check system configuration
				if [ 0 != `sysctl -n net.add_addr_allfibs` ]; then
				atf_skip "This test requires net.add_addr_allfibs=0"
				fi
				get_fibs 1

				setup_tap "$FIB0" inet6 ${ADDR0} $MASK
				ifconfig $TAP mtu 9000

				atf_check -s exit:0 -o ignore setfib $FIB0 route -6 change \
				${SUBNET}/${MASK} -mtu 8723

				# Just searching for "8723" is awful, but the output of 'route get' is
				# not amenable to parsing
				atf_check -o match:8723 setfib $FIB0 route -6 get $ADDR1
				}

				ipv6_change_route_without_dest_cleanup()
				{
				cleanup_ifaces
				}

				atf_init_test_cases()
				{
				atf_add_test_case ipv4_change_route_without_dest
				atf_add_test_case ipv6_change_route_without_dest
				}