diff --git a/net/realtek-re-kmod/Makefile b/net/realtek-re-kmod/Makefile
index fbf1c8e9ae88..0a6cffedba27 100644
--- a/net/realtek-re-kmod/Makefile
+++ b/net/realtek-re-kmod/Makefile
@@ -1,23 +1,24 @@
 PORTNAME=	re
 PORTVERSION=	1100.00
 DISTVERSIONPREFIX=	v
+PORTREVISION=	1
 CATEGORIES=	net
 PKGNAMEPREFIX=	realtek-
 PKGNAMESUFFIX=	-kmod
 
 MAINTAINER=	ale@FreeBSD.org
 COMMENT=	Kernel driver for Realtek PCIe Ethernet Controllers
 WWW=		https://github.com/alexdupre/rtl_bsd_drv
 
 LICENSE=	BSD4CLAUSE
 
 USES=		kmod tar:tgz uidfix
 
 USE_GITHUB=	yes
 GH_ACCOUNT=	alexdupre
 GH_PROJECT=	rtl_bsd_drv
 GH_TAGNAME=	ea4ed1e
 
 PLIST_FILES=	${KMODDIR}/if_re.ko
 
 .include <bsd.port.mk>
diff --git a/net/realtek-re-kmod/pkg-message b/net/realtek-re-kmod/pkg-message
index 04c8a05a9b71..07b478dccc53 100644
--- a/net/realtek-re-kmod/pkg-message
+++ b/net/realtek-re-kmod/pkg-message
@@ -1,28 +1,35 @@
 [
 { type: install
   message: <<EOM
 Add the following lines to your /boot/loader.conf
 to override the built-in FreeBSD re(4) driver.
 
 if_re_load="YES"
 if_re_name="/boot/modules/if_re.ko"
 
 By default, the size of allocated mbufs is enough
 to receive the largest Ethernet frame supported
 by the card.  If your memory is highly fragmented,
 trying to allocate contiguous pages (more than
 4096 bytes) may result in driver hangs.
 For this reason the value is tunable at boot time,
 e.g. if you don't need Jumbo frames you can lower
 the memory requirements and avoid this issue with:
 
 hw.re.max_rx_mbuf_sz="2048"
 
 To enable Wake on LAN (WoL) support you might need
 to set the following tunables:
 
 hw.re.s5wol="1"
 hw.re.s0_magic_packet="1"
+
+If you experience network hangs with IPv6 enabled,
+you might need to disable the checksum offloading
+by adding the following parameters to the related
+ifconfig line in your /etc/rc.conf file:
+
+-rxcsum -txcsum -rxcsum6 -txcsum6
 EOM
 }
 ]