Cleanup USES=go ports:
- Remove custom build/install targets left in place after r505321
- Switch to the new GO_TARGET tuple syntax introduced in r512001
dmgk on Sep 19 2019, 5:02 PM.Authored by
Cleanup USES=go ports:
poudriere bulk: OK (113a, 120a)
Since i am very unfamiliar with the go ports, i have problems to understand this diff.
Is there any reason why removing the unneeded build-steps and the switch to GO_TARGET are in the same commit? With my limited understanding i would say this are two different changes with two different reasons to do so. So, can you explain me what you want to archive and why this is a single commit? This should be also reflected later in the commit message, because i am not the only one with limited go experience ;)
r505321 converted all ports to USES=go which already provides do-build and do-install targets. During that conversion, ports that were defining their own build/install targets were left alone to be cleaned up later. This commit does this cleanup for the ports that I maintain.
Removing targets doesn't remove any build steps, just switches the port to use default targets that go.mk provides.
GO_TARGET is used by go.mk in do-build and do-install, it doesn't make sense to set it with custom targets and removing custom targets w/o setting GO_TARGET would break the build.
As you are working on this already for a while, how about ports that you are not a maintainer? Maybe an exp-run following with a portmgr@ approval would be interesting to clean up the rest of the ports.
What do you think? Is it something worth to do?
That was my plan actually, I was just not sure what would be the best way to get something like that reviewed/committed. The complete diff is about 250KB, I was thinking about maybe breaking it to 3-4 parts for easier review. Would that make sense or it would be better to post it in a single review?
It depends on the diff. If it is the same line changed over 1.000 ports - that is fine as a single review. If we need to check various things, its better to break it down. Beside the good suggestion "by category" you can also use "by type of change" or "by not-maintained and maintained" and any combination of this.
The diff I plan to submit has the same type of changes as in this one - removing custom targets, adding GO_TARGET and GO_PKGNAME instead, e.g. cleanup and finalizing migration to go.mk. I think splitting it to a few parts by category is a good plan because all affected ports have the same scope of changes.